Rotate · Pan · Zoom
Drag to rotate. Two-finger drag or right mouse to pan. Pinch or scroll to zoom.
Measure
Tap Measure, then tap two points on the model. The value appears next to the measurement line and is saved in your measurement history.
Measurements
Use the history button at the top to open saved measurements for this model. Tap a saved measurement to show it on the model, or use Clear all to remove saved measurements from this device.
Reset View
Tap Reset View to reset the camera and remove the cut. Saved measurements stay in your history.
Measurement snapping
When Measure mode is active, small snap markers show where your next measurement point will be placed. This helps you measure from accurate parts of the model instead of guessing. Move the pointer near corners or edges to find more accurate snap points. If the model is cut, snap markers only refer to visible parts.
Square = corner or end point
Triangle = middle of an edge
Diamond = nearest point on an edge
Circle = surface point when no closer snap is found
Cut
Tap Cut, tap a face, then drag to cut through the model.
Focus
Double-click (or double-tap) a part to frame it.